Windows Overlays Window

<Prev Next>

Experimental Overlays

	Load overlay file. Note that the upper button loads a single overlay file, clearing the current overlay. The lower button adds to the current overlay.
	Save all overlays
	Save all overlays to a different file. Note that the upper button saves all overlays, the lower just the current one.
	Copy current overlay to clipboard
	Add another overlay from the clipboard
	Fix all parameters, i.e. set Float = "no" for all parameters.
	Cycle through units (cm-1, nm, MHz, Kelvin and eV), converting parameter values as appropriate each time. For overlays this is not normally required, as PGOPHER will normally do the required conversions.
	Add overlay from file. Note that the upper button loads a single overlay file, clearing the current overlay.
	Export current overlay to file. Note that the upper button saves all overlays, the lower just the current one.
	Copy peaks to clipboard
	Delete peaks from this overlay
	Perform various operations on the spectrum; many of these can also be performed by right clicking on the overlay on the main window, if it is plotted separately from other traces. Invert Each the intensity at each point, I, becomes Imax + Imin - I Crop Discard points outside selected range, as specified as FirstPoint to LastPoint. These can be set to the current visible region by right clicking on the overlay in the main window and selecting "Select Visible". Find Zero Uses a heuristic to attempt to set baseline to the probable zero level of the spectrum. Join To... Add selected spectrum to the current spectrum; if done from the main window the join point is at the mouse position, otherwise any overlap region is divided equally between the two spectra. Join All,Unscaled Join all spectra of this type together, ignoring the vertical scaling Join All,Scaled Join all spectra of this type together, using the vertical scaling Smooth... Smooth (and differentiate) spectrum Compress... Compress the spectrum by either: averaging every n points together averaging all points within a specified interval, to give points on a regular grid. (This can expand the spectrum if the interval is less than the starting interval.) A dialog box allows the choice to be made. Discard Frequency Replace frequency with point number Discard Intensity Set Intensity to 1, and convert to linelist Separate Produce two independent intensity channels from frequency and intensity Swap x and y Swap frequency and intensity channels